topic Re: Predefined schemes for Surface Schedules missing - even when in "New & Reset All" in Project data & BIM

Predefined schemes for Surface Schedules missing - even when in "New & Reset All"

alexliz — Fri, 30 Jan 2026 06:30:22 GMT

It's all in the title, guys. Here's the backstory:

I needed to start off one of the pre-canned schedules for surfaces, I clicked on it, but it isn't listing anything from the project. I went into its Settings and saw that all the 'is in branch of' criteria are empty:

Weird, I thought. I did a 'New & Reset All' and see this:

Here's what's loaded in my Libraries:

Thanks for any help.

Re: Predefined schemes for Surface Schedules missing - even when in "New & Reset All"

Ricardo Lopez — Fri, 30 Jan 2026 06:29:39 GMT

Hi @alexliz

Is the Archicad Classification - v 2.0 available in the Classification Manager?

Re: Predefined schemes for Surface Schedules missing - even when in "New & Reset All"

Barry Kelly — Thu, 29 Jan 2026 00:52:13 GMT

New & Reset All may just load a default template that may not be fully set up.

You can download language specific templates here....

https://www.graphisoft.com/resources-and-support/downloads/?section=cross-border-cooperation&localization=INT

Just choose your language.

I am not sure if they will be set up any differently.

Barry.

Re: Predefined schemes for Surface Schedules missing - even when in "New & Reset All"

alexliz — Thu, 29 Jan 2026 08:37:18 GMT

Thank you both. I have Archicad Classification - v 2.0 loaded, but it's from a different location on the hard disk (I have exported the set from a past template) so I am guessing Archicad is treating it as different. I am now resetting the criteria based on the loaded set.

As for the New & Reset All: I was starting the new project trial project based on a template that did not include any schedules - my bad. I selected the AC28INT template and all is good.