https://community.graphisoft.com/t5/Project-data-BIM/Zone-Volume-Calculation/m-p/251490#M4923 Yes, ArchiCAD calculates actual volume of zone. It was introduced even before SEO - was function (and still exists) to cut zone to roof slope. So, if zone volume was calculated when it cut under the roof - why should be different if you use SEO?<BR /> I think, you can schedule zone volumes if you choose Volume in general parameters group. Sun, 23 May 2021 01:06:00 GMT Podolsky 2021-05-23T01:06:00Z https://community.graphisoft.com/t5/Project-data-BIM/Zone-Volume-Calculation/m-p/251489#M4922 <DIV class="actalk-migrated-content"><T>I have a zone that is being cut with a SEO.<BR /> can i measure the new volume and schedule it? <BR /> <BR /> The zone stamp provides a volume measurement, as you can see in the attached image, which does change if do a SEO. So i am guessing its not just calculating area multiplied by height.<BR /> is this a correct measurement? and if yes how can i schedule it? i couldn't even find it in the library part parameters.<BR /> <BR /> the next idea is to use the general Net Volume (Gross and Conditional show nothing). again i am not sure if its a correct measurement but the results are the same as the ones displayed inside the zone stamp.</T></DIV> Fri, 19 May 2023 21:51:34 GMT https://community.graphisoft.com/t5/Project-data-BIM/Zone-Volume-Calculation/m-p/251489#M4922 Anonymous 2023-05-19T21:51:34Z https://community.graphisoft.com/t5/Project-data-BIM/Zone-Volume-Calculation/m-p/251490#M4923 Yes, ArchiCAD calculates actual volume of zone. It was introduced even before SEO - was function (and still exists) to cut zone to roof slope. So, if zone volume was calculated when it cut under the roof - why should be different if you use SEO?<BR /> I think, you can schedule zone volumes if you choose Volume in general parameters group. Sun, 23 May 2021 01:06:00 GMT https://community.graphisoft.com/t5/Project-data-BIM/Zone-Volume-Calculation/m-p/251490#M4923 Podolsky 2021-05-23T01:06:00Z