topic Is there a way to control WALLHOLE, WALLINCHE lines in section? said not to appear in GDL

Is there a way to control WALLHOLE, WALLINCHE lines in section? said not to appear

LeeJaeYoung — Wed, 26 Apr 2023 15:00:35 GMT

I use WALLHOLE 1 , WALLINCHE 1 .
It seems that there are a lot of section lines, so it is good that only the two outer lines appear.

Re: Is there a way to control WALLHOLE, WALLINCHE lines in section? said not to appear

Piotr Dobrowolski — Thu, 27 Apr 2023 03:57:11 GMT

If You set a switch to unify all surfaces on cut (by material statement prior to wallhole or wallniche with status "2") preferably only for sections then it would do the trick.