https://community.graphisoft.com/t5/Libraries-objects/What-side-of-the-wall-am-I-looking-at/m-p/149451#M22754 <DIV class="actalk-migrated-content"><T>I've made a little wall label which serves as finishes marker. This reads the material of the wall but after a couple of hours research I'm still struggling to figure out how to determine which side of the wall I'm looking at (as different materials can be applied to the 3 vertical sides).<BR /> There seems to be no obvious request parameters for the section or internal elevation tool which would enable me to figure this out geometrically.<BR /> Right now I just have a check box which says - use the other side! ...not very elegant or robust. Especially when compared to the fine materials list I have which is in turn nicely co-ordinated with my finishes schedule!<BR /> Any clues people?</T></DIV> Tue, 01 Dec 2009 20:34:17 GMT Anonymous 2009-12-01T20:34:17Z https://community.graphisoft.com/t5/Libraries-objects/What-side-of-the-wall-am-I-looking-at/m-p/149451#M22754 <DIV class="actalk-migrated-content"><T>I've made a little wall label which serves as finishes marker. This reads the material of the wall but after a couple of hours research I'm still struggling to figure out how to determine which side of the wall I'm looking at (as different materials can be applied to the 3 vertical sides).<BR /> There seems to be no obvious request parameters for the section or internal elevation tool which would enable me to figure this out geometrically.<BR /> Right now I just have a check box which says - use the other side! ...not very elegant or robust. Especially when compared to the fine materials list I have which is in turn nicely co-ordinated with my finishes schedule!<BR /> Any clues people?</T></DIV> Tue, 01 Dec 2009 20:34:17 GMT https://community.graphisoft.com/t5/Libraries-objects/What-side-of-the-wall-am-I-looking-at/m-p/149451#M22754 Anonymous 2009-12-01T20:34:17Z