topic Re: Has anybody used the AUTO CURVE tool from the depositary in Libraries & objects

Has anybody used the AUTO CURVE tool from the depositary?

Anonymous — Fri, 07 Aug 2009 15:19:51 GMT

I downloaded the AUTO CURVE tool from the depositary and is a great tool which I think I can get out a lot of use but it is in Hungarian and there are somethings that even with a hungarian-English translation are not clear.
Has anybody has taken the time to translate it all?
Thanks!

Re: Has anybody used the AUTO CURVE tool from the depositary

Anonymous — Fri, 07 Aug 2009 23:15:26 GMT

Try these ones by cadimage instead. You have to register, but they are free and in english!

http://www.cadimagetools.com/trackingcurves_main.aspx

There is a short video of it here - http://www.youtube.com/watch?v=y-h7WeKTjf4

Re: Has anybody used the AUTO CURVE tool from the depositary

Anonymous — Mon, 10 Aug 2009 23:01:53 GMT

Hi Peter,
Thank you very much! this is what I needed, thanks again., do you know what is the minimum turning radius for a car?

Re: Has anybody used the AUTO CURVE tool from the depositary

Anonymous — Mon, 10 Aug 2009 23:30:05 GMT

rucailo wrote:
... do you know what is the minimum turning radius for a car?

It depends which car. I'd use a large car like a Volvo estate and then you know most cars should be smaller.

There is a link to a pdf of the full specifications for a Volvo V70 near the bottom of this page. http://www.volvoclub.org.uk/press/volvo2007uk/index.shtml

Hope that helps!

Re: Has anybody used the AUTO CURVE tool from the depositary

Anonymous — Mon, 10 Aug 2009 23:45:56 GMT

Thanks!

Re: Has anybody used the AUTO CURVE tool from the depositary

Anonymous — Mon, 27 Aug 2012 05:24:54 GMT

Hi there,

I was looking for that library part but looks like it's not available for cars anymore. Does anyone know where to find it or could possibly email it to me?

Cheers,

Claudio