topic Re: Openings - Arched openings as doors in Libraries & objects

Openings - Arched openings as doors

Anonymous — Wed, 24 May 2023 08:57:53 GMT

I'm using v10, and when I insert an opening as a door, the edge of the opening (perpendicular to the wall surfaces) is open. I've been drawing in a line to make it more representative of a true arched opening but I don't recall having to do this with earlier versions of ArchiCAD.

Thanks
Ed-Rab
Mac Book Pro, Leopard 10.5.6, 2.5 GHz, Intel Core 2 Duo, 4GB, ArchiCAD v10

Re: Openings - Arched openings as doors

Erika Epstein — Wed, 18 Mar 2009 17:45:04 GMT

Please post a screenshot of your settings and placed door/openings; I can't reproduce what you describe.

Re: Openings - Arched openings as doors

Erich — Wed, 18 Mar 2009 23:02:29 GMT

From your post it sounds as though you are seeing this in 2D and adding the line in plan. Is that right? Since I don't have 10 loaded right now, I will guess based on 11. Do you have the "Connection on the left" and "Connection on the right" turned on? If so, and if the settings are similar enough, turn them both off.

If this is not what you are talking about, then a picture is worth a thousand words...

Re: Openings - Arched openings as doors

Anonymous — Fri, 20 Mar 2009 19:17:04 GMT

Thanks for the comments;
see attached screen capture.

I added one other issue - where wall corners do not "flow" as the two on the left but the two on the right do.

Re: Openings - Arched openings as doors

Erich — Sat, 21 Mar 2009 03:56:03 GMT

Did you check out the connection lines for the opening?

For the walls, make sure that the wall reference lines match up. Typically, this will mean having them on the outside face of the wall. Be aware that they are also directional and should be moving in the same direction.

You can check on this by going to

Display > Display only options > Walls and Beams Reference Lines.

This will highlight the reference line of the wall and add an arrow to the line to indicate direction.

HTH

Re: Openings - Arched openings as doors

David Maudlin — Sat, 21 Mar 2009 12:57:34 GMT

Ed_Rab wrote:
I'm using v10, and when I insert an opening as a door, the edge of the opening (perpendicular to the wall surfaces) is open. I've been drawing in a line to make it more representative of a true arched opening but I don't recall having to do this with earlier versions of ArchiCAD.

Ed:

For the D Arch Opening 10, change the Wall Contours parameter to 1, if you stretch the dialog box you will see the various options: Wall Contours (0-None,1-Full,2-Side,3-Length). For version 10, this interface element is primitive (entering numbers for various options, rather than a pop up list).

David