topic Re: Door Problem in Libraries & objects

Door Problem

Anonymous — Wed, 24 May 2023 08:57:51 GMT

When I go to place a double door (a D2 or in this case a D2 Segmented Transom) the door panel width always changes on me. For example, I place the door with the default width, let's say 5'-0". Let's say I go to enlarge the door to a 6'-0" width, this is where the problem arises. One panel stays at 2'-6" wide and the other goes to 3'-6" wide. I know under "Elevation and Opening" you can change the width to match (you have to manually do the math for it and type it in), but in this specific case that is grayed out and I cannot do anything. Shouldn't the door panels automatically be the same width anyway? What is happening in this specific case that I cannot change the width?

Re: Door Problem

Anonymous — Thu, 19 Mar 2009 14:19:56 GMT

72 Views and no answer? Can anyone replicate this issue? Does it work for anyone? Is this a bug? Should I complain to Graphisoft? Am I asking too many questions? Is anyone annoyed? Is anyone listening? My avatar is lonely....

Re: Door Problem

Anonymous — Thu, 19 Mar 2009 16:46:54 GMT

Maybe a screenshot will help?
Architects tend to see problems visually.

Re: Door Problem

Anonymous — Thu, 19 Mar 2009 17:08:57 GMT

Maybe I just stumped everyone

Re: Door Problem

Erika Epstein — Thu, 19 Mar 2009 19:00:43 GMT

It's a known problem and has been discussed in earlier posts.

Re: Door Problem

Anonymous — Fri, 20 Mar 2009 10:35:22 GMT

Steven wrote:
72 Views and no answer? Can anyone replicate this issue? Does it work for anyone? Is this a bug? Should I complain to Graphisoft? Am I asking too many questions? Is anyone annoyed? Is anyone listening? My avatar is lonely....

maybe if you ask into the correct discussion (like "working in AC")

Re: Door Problem

Stress Co_ — Sun, 22 Mar 2009 22:27:33 GMT

Look in "Door Panel" Parameters for "Panel Division Type".
Check: Proportional

and a screen shot for us Architects

Re: Door Problem

Erika Epstein — Mon, 23 Mar 2009 04:15:52 GMT

Stress wrote:
Look in "Door Panel" Parameters for "Panel Division Type".
Check: Proportional

and a screen shot for us Architects

Unfortunately, for the D2 Segmented Transom , this option is not available