https://community.graphisoft.com/t5/Libraries-objects/Extrude-Question/m-p/84549#M40584 <DIV class="actalk-migrated-content"><T>Why doesn't the following code work in 8.1?<BR /> <BR /> In the Master script I have:<BR /> PUT 0,wr/2,0, !L-iron section<BR /> ld,wr/2,0,<BR /> ld,lt+wr/2,0,<BR /> lt,lt+wr/2,0,<BR /> lt,ld+wr/2,0,<BR /> 0,ld+wr/2,0,<BR /> 0,wr/2,0<BR /> <BR /> In the 3D script I have:<BR /> EXTRUDE nsp/3,0,0,tchord,55,USE(nsp)<BR /> <BR /> If I check the 3D GDL script I get the message:<BR /> "Not enough edges in generatrix at line 11..."<BR /> <BR /> Note: this is an old GDL written in 2001.</T></DIV> Fri, 16 Jul 2004 22:37:43 GMT Anonymous 2004-07-16T22:37:43Z https://community.graphisoft.com/t5/Libraries-objects/Extrude-Question/m-p/84549#M40584 <DIV class="actalk-migrated-content"><T>Why doesn't the following code work in 8.1?<BR /> <BR /> In the Master script I have:<BR /> PUT 0,wr/2,0, !L-iron section<BR /> ld,wr/2,0,<BR /> ld,lt+wr/2,0,<BR /> lt,lt+wr/2,0,<BR /> lt,ld+wr/2,0,<BR /> 0,ld+wr/2,0,<BR /> 0,wr/2,0<BR /> <BR /> In the 3D script I have:<BR /> EXTRUDE nsp/3,0,0,tchord,55,USE(nsp)<BR /> <BR /> If I check the 3D GDL script I get the message:<BR /> "Not enough edges in generatrix at line 11..."<BR /> <BR /> Note: this is an old GDL written in 2001.</T></DIV> Fri, 16 Jul 2004 22:37:43 GMT https://community.graphisoft.com/t5/Libraries-objects/Extrude-Question/m-p/84549#M40584 Anonymous 2004-07-16T22:37:43Z https://community.graphisoft.com/t5/Libraries-objects/Extrude-Question/m-p/84550#M40585 I've experemented with your codes, the error is due to ld=0 &amp; wr=0.<BR /> Probably, you haven't defined ld &amp; wr. Sat, 17 Jul 2004 02:18:57 GMT https://community.graphisoft.com/t5/Libraries-objects/Extrude-Question/m-p/84550#M40585 LiHigh 2004-07-17T02:18:57Z