topic Re: Floor plan cut plane settings? in Licensing

Floor plan cut plane settings?

Anonymous — Thu, 25 May 2023 16:14:10 GMT

Hi guys,
I'm on a roll this week!!... Thought I could just fit this last question in seeing as its Friday
I did a quick search before posting this thread, but found no joy there.

I want to draw up 3 horizontal sections through some kitchen cabinets and thought it would make sense to use the Floor PLan Cut Plane settings at three different heights to achieve this.

I have 3 plan views in my View map and thought I could adjust the FPCP settings individually and get my 3 sections.

However, adjusting the values doesn't seem to make any difference to what I see apart from the walls? I put 3 different height walls and they seem to register the change but the slabs I used for my cabinets shoe no change.
I tried to set a cup plane higher than the floor to see if the floor disappeared but it didn't seem to make a difference either?

Also I set the height to 750mm from floor and my overhead cupboards were still in view?

Have a great weekend

thanks Tony

Re: Floor plan cut plane settings?

__archiben — Fri, 23 May 2008 06:31:54 GMT

try switching your cabinet objects from 'Symbolic' to 'Projected' . . .

any good?

~/archiben

Re: Floor plan cut plane settings?

Barry Kelly — Fri, 23 May 2008 08:36:35 GMT

~/archiben wrote:
try switching your cabinet objects from 'Symbolic' to 'Projected' . . .

any good?

~/archiben

Objects don't have that ability do they?
Only walls (including doors & windows), columns, beams and roofs.
Barry.

Re: Floor plan cut plane settings?

__archiben — Fri, 23 May 2008 08:49:51 GMT

Barry wrote:
Objects don't have that ability do they?

probably not! i wasn't in front of archicad and took a flyer based on windows and doors being able to . . .

you got me!

cheers
~/archiben

Re: Floor plan cut plane settings?

Anonymous — Mon, 26 May 2008 00:41:29 GMT

Thanks for the repleys guys,

In the end I just created a detail of the cabinets and drew them @ the 3 levels in 2D..

Thanks for the input all the same...

Tony

Re: Floor plan cut plane settings?

Djordje — Tue, 27 May 2008 16:48:56 GMT

Barry wrote:
~/archiben wrote:
try switching your cabinet objects from 'Symbolic' to 'Projected' . . .

any good?

~/archiben
Objects don't have that ability do they?
Only walls (including doors & windows), columns, beams and roofs.
Barry.

AFAIR some do ... but then, it might have been the 11 beta.

My brain is fried ... and too old ... 😉