topic Re: Imported morph in Twinmotion is only visable from one direction in Visualization

Imported morph in Twinmotion is only visable from one direction

Feanix — Fri, 30 May 2025 19:21:40 GMT

Hello!

I got a problem with the visualisation of a project.

In the pictures you can see my problem.

You can see the morphs (These are membranes in real life) are only visable from one side.

I tried every way to save the project as .fbx and every way to import it in Twinmotion, but it stays this way.

What can I do about it?

Re: Imported morph in Twinmotion is only visable from one direction

KenMcN — Fri, 30 May 2025 19:30:54 GMT

I think you need to tell the material to be 2-sided. Sorry, can’t remember if that’s in the material definition or the object settings (but I hope it’s the material, so you can change them all at once).

Hope this is right and it helps.

Kenny

Re: Imported morph in Twinmotion is only visable from one direction

Feanix — Fri, 30 May 2025 21:46:01 GMT

Im gonna try that. Altough I dont know if you can do that with a morph.

Edit: Nope, doesnt work. There is no way to tell the morph its two sided.

Re: Imported morph in Twinmotion is only visable from one direction

mikas — Sun, 01 Jun 2025 17:56:28 GMT

Not sure you tried it allready, but I think KenMcN ment you should set it up in TwinMotion, not in ArchiCAD. I have had these situations too and I did solve them by choosing two-sided material in TwM for the object.

HTH.

Re: Imported morph in Twinmotion is only visable from one direction

KenMcN — Sun, 01 Jun 2025 19:04:45 GMT

Sorry, thought I'd replied to say that as well, but it must have gotten lost. Yes, the material needs to be edited in TM , rather than Archicad.
Thanks Mikas