topic Re: Schedule Criteria Help in Collaboration with other software

Schedule Criteria Help

Anonymous — Thu, 05 May 2016 05:27:08 GMT

Hello,

I am trying to figure out how to correctly use these scheduling criteria.

I am doing a schedule for the lintels/studs ect. Where I want to show all the windows but only a select few doors (as seen in the picture).

I attempted to use the nesting but I think I was doing it wrong...

So far It will end up either only showing the doors I want to show or all the windows, or just all the doors and windows as ive been messing about with different settings.

The picture attached shows the settings ive been trying which only show the doors and none of the windows.

Re: Schedule Criteria Help

Barry Kelly — Thu, 05 May 2016 06:11:01 GMT

Try some extra nesting for the door otherwise your ID criteria is being applied to the windows as well.

See red mark-up in attached image.

Barry.

Re: Schedule Criteria Help

Anonymous — Thu, 05 May 2016 07:22:46 GMT

Barry wrote:
Try some extra nesting for the door otherwise your ID criteria is being applied to the windows as well.

See red mark-up in attached image.

Barry.

Ah that's where I was going wrong!

Thank you, that gets the result I was looking for