https://community.graphisoft.com/t5/Collaboration-with-other/CADIMAGE-Garage-door/m-p/289562#M37835 Good question! The door really shouldn't do that, very difficult to open I would think. We'll fix this ASAP.<BR /> In the meantime you can work around it by setting the 'Door Side Room' to a negative value. This will make the door narrower. If the frame width is 30mm, set the 'Door Side Room' to -30mm.<BR /> Tue, 28 Jan 2020 16:16:49 GMT Anonymous 2020-01-28T16:16:49Z https://community.graphisoft.com/t5/Collaboration-with-other/CADIMAGE-Garage-door/m-p/289561#M37834 <DIV class="actalk-migrated-content"><T>is there a setting for the door not to intersect with the frame? it seems there isn't</T></DIV> Fri, 24 Jan 2020 13:03:28 GMT https://community.graphisoft.com/t5/Collaboration-with-other/CADIMAGE-Garage-door/m-p/289561#M37834 Anonymous 2020-01-24T13:03:28Z https://community.graphisoft.com/t5/Collaboration-with-other/CADIMAGE-Garage-door/m-p/289562#M37835 Good question! The door really shouldn't do that, very difficult to open I would think. We'll fix this ASAP.<BR /> In the meantime you can work around it by setting the 'Door Side Room' to a negative value. This will make the door narrower. If the frame width is 30mm, set the 'Door Side Room' to -30mm.<BR /> Tue, 28 Jan 2020 16:16:49 GMT https://community.graphisoft.com/t5/Collaboration-with-other/CADIMAGE-Garage-door/m-p/289562#M37835 Anonymous 2020-01-28T16:16:49Z