https://community.graphisoft.com/t5/Collaboration-with-other/Composite-Wall-skins-not-showing-in-elevation-3D-but-only-in-one/m-p/336439#M40068 <P>Can you show a 3D image?</P> <P>I am guessing it is being trimmed by another wall - especially if it is part of a wall inside another wall.</P> <P>&nbsp;</P> <P>Barry.</P> Fri, 22 Apr 2022 14:00:40 GMT Barry Kelly 2022-04-22T14:00:40Z https://community.graphisoft.com/t5/Collaboration-with-other/Composite-Wall-skins-not-showing-in-elevation-3D-but-only-in-one/m-p/336433#M40067 <P>Here's a strange one. I have a composite wall made up of a core and one finish layer on each side. Pretty simple. I also have an existing wall that has a part of it demolished and this new composite wall will partially rebuild some of it. Same thickness. Now for some reason whenever I place any wall around that area, none of the non-core skins show up in elevation or 3D. I've placed various different walls in that area, same deal. It's not the new composite wall I created because it works elsewhere in the plan, it's just this one spot. Any ideas what might be causing this?</P><P>I've deleted and replaced the wall, phasing, different walls, etc.</P><P>thank you,</P> Fri, 22 Apr 2022 11:30:16 GMT https://community.graphisoft.com/t5/Collaboration-with-other/Composite-Wall-skins-not-showing-in-elevation-3D-but-only-in-one/m-p/336433#M40067 kyojim 2022-04-22T11:30:16Z https://community.graphisoft.com/t5/Collaboration-with-other/Composite-Wall-skins-not-showing-in-elevation-3D-but-only-in-one/m-p/336439#M40068 <P>Can you show a 3D image?</P> <P>I am guessing it is being trimmed by another wall - especially if it is part of a wall inside another wall.</P> <P>&nbsp;</P> <P>Barry.</P> Fri, 22 Apr 2022 14:00:40 GMT https://community.graphisoft.com/t5/Collaboration-with-other/Composite-Wall-skins-not-showing-in-elevation-3D-but-only-in-one/m-p/336439#M40068 Barry Kelly 2022-04-22T14:00:40Z