topic Re: Publishing Cover Fills to AutoCAD in Collaboration with other software

Publishing Cover Fills to AutoCAD

kevin b — Tue, 19 Apr 2005 13:09:15 GMT

Am I doing something wrong here?

We use slabs for our ceilings, with cover fills for the ceiling tile patterns. Cover fills on or off depending on the view. In the past we used a separate fill on its own layer which was only on in RCPs. When we try to publish to AutoCAD to send RCPs to consultants, the fills do not show up. I tried creating new translators to give the cover fills their own AutoCAD layer, exporting them as all solid, exporting backgrounds as separate hatches, nothing seems to work. It seems like we will have to go back to using a separate fill to export the grids for our consultants, which of course creates potential problems with coordinating and updating.

Any help would be appreciated.

Re: Publishing Cover Fills to AutoCAD

kevin b — Tue, 19 Apr 2005 13:17:08 GMT

Just to add some detail...

It is all fills, not just our ceiling grid, we have other fills for gypsum ceilings and soffits, etc.

We do get a polyline in AutoCAD at the perimeter of the slab which should have the cover fill on it. The polyline is on the correct layer, etc. just no fill.

Thanks again.

Re: Publishing Cover Fills to AutoCAD

Greg Kmethy — Wed, 20 Apr 2005 14:19:21 GMT

This is a bug. When saving DWG, the cover fill display is controlled by the cut fill display options. That is, if cut fills are off, cover fills will be off too. You probably have cut fills off in your view that you are exporting. If it's not a problem to turn cut fills on, then that's the workaround.

Greg

Re: Publishing Cover Fills to AutoCAD

kevin b — Thu, 23 Jun 2005 21:17:32 GMT

In this particular scenario, cut fills are off in display options, and we would like to keep them off. Any word on a bug fix for this?

Re: Publishing Cover Fills to AutoCAD

Anonymous — Wed, 06 Jul 2005 17:08:10 GMT

was this fixed in the latest patch?

Re: Publishing Cover Fills to AutoCAD

kevin b — Wed, 06 Jul 2005 17:58:30 GMT

No, I just tested it and it still does not work as it should.

Re: Publishing Cover Fills to AutoCAD

Anonymous — Wed, 06 Jul 2005 18:20:29 GMT

kevin wrote:
No, I just tested it and it still does not work as it should.

Thanks for the test.

GRAPHISOFT!!!