topic Re: AC-11 is showing two projects at once.... in Installation & update

AC-11 is showing two projects at once....

Anonymous — Mon, 12 May 2008 15:04:02 GMT

I've just had a weird experience. After looking at a layout, I used F2 to switch back to Model view. I was brought back to the model view of the project I had been working on before this one.

I had been working on project X, finished, saved, and opened project Y.
I worked on project Y for about half an hour, then switched to layout view to check the floor plan output. When I used F2 to revert to model view, the project X model view showed up. Using either CMD-` or the navigator to switch between windows had the same results. Closing and reopening has (knock wood) cured the problem so far.

Whiskey Tango Foxtrot?

I have had many of the problems others have reported in installing Hotfix 1200, and finally succeeded with a reinstall from scratch. So far AC-11 is resistant to Hotfix 1210, and I don't want to go all the way through from scratch again.

Any ideas?

Re: AC-11 is showing two projects at once....

Dwight — Mon, 12 May 2008 15:48:18 GMT

Before you call a priest, just be sure you don't two Archicads open at once.

Re: AC-11 is showing two projects at once....

Anonymous — Tue, 13 May 2008 13:59:32 GMT

Dwight:

That was the first thing I checked...

Re: AC-11 is showing two projects at once....

Stress Co_ — Tue, 13 May 2008 14:38:58 GMT

I've had something similar happen in the Navigator Preview window. "Redraw Preview" and it was gone.

Re: AC-11 is showing two projects at once....

Ralph Wessel — Fri, 16 May 2008 13:42:14 GMT

Peter wrote:
I've just had a weird experience. After looking at a layout, I used F2 to switch back to Model view. I was brought back to the model view of the project I had been working on before this one.

I've also experienced this, although only 3 times in the last 4-5 months. Unfortunately, in 2 cases it happened sitting in front of a client - very embarrassing. The only possible trend is that it seems to happen if I go straight to the 3D window after opening a project and do a few operations there. When I go back to the 2D plan, I'm looking at the previous project. Eventually all views display the previous project and all changes I've made are lost. Weird in the extreme!

Re: AC-11 is showing two projects at once....

Djordje — Sat, 17 May 2008 17:32:24 GMT

I had it in Organizer ... also Navigator Preview.