topic Re: Interactive Schedule in Installation & update

Interactive Schedule

Red — Thu, 08 Jan 2004 16:32:24 GMT

I'm having problems setting up a schedule with this criteria.

Basically I'm wanting the schedule to only select certain objects and list the following.

1. Objectname (only certain objects not everyone that is in the drawing)

2. Layer of that object

3. Story that the object is on

4. ID of the object

I have no use for any of the parameters within the objects.

Re: Interactive Schedule

David Larrew — Thu, 08 Jan 2004 17:03:07 GMT

Red wrote:
Basically I'm wanting the schedule to only select certain objects and list the following.

1. Objectname (only certain objects not everyone that is in the drawing)

2. Layer of that object

3. Story that the object is on

4. ID of the object

It is possible...

1. Set "Object Type" and "Object Name" under the "General" tab.

2/3/4. Select (check) "Layer", "Floor (Story)", and "ID" under the "Fields" tab.

Re: Interactive Schedule

Red — Thu, 08 Jan 2004 20:41:31 GMT

Under the general tab how do you set it up to look for certain objects. I see where you can go into additional parameters and have it look at certain objects parameters.

Re: Interactive Schedule

Red — Thu, 08 Jan 2004 21:26:27 GMT

After a few minutes of pulling my hair out I figured it out. Thanks David for your help.

Re: Interactive Schedule

Red — Fri, 09 Jan 2004 18:54:10 GMT

Unless I have overlooked it can you also have it to show the objects link?

Re: Interactive Schedule

Karl Ottenstein — Sat, 10 Jan 2004 02:56:57 GMT

Red wrote:
Unless I have overlooked it can you also have it to show the objects link?

By link do you mean the path in the file system to the actual object (or the PLA containing it)? If so, nope, AFAIK there isn't a way to show that.

Karl

Re: Interactive Schedule

Red — Mon, 12 Jan 2004 12:57:17 GMT

Im referring to the link for BOMs. (Properties)