https://community.graphisoft.com/t5/Modeling/join-lines-in-elevations-and-3d/m-p/190572#M103361 If I understand what you are trying to do correctly, <BR /> Try going into your "wall selection settings" of the wall intersecting perpendicular and changing the "wall priority" by dragging the slider either way so it is a different value. This should clean up that line.<BR /> Hope that makes sense. Thu, 17 Mar 2011 01:42:19 GMT Anonymous 2011-03-17T01:42:19Z https://community.graphisoft.com/t5/Modeling/join-lines-in-elevations-and-3d/m-p/190571#M103360 <DIV class="actalk-migrated-content"><T>I have a standard corner 90 degree wall to which I want white walls to the inside and coloured to the other. On one side of the wall I am adding a wall projecting to meet the eaves of the roof over. this wall I am making coloured on all sides as its outside.<BR /> <BR /> How can I acheive the same thing without seeing the joint line in both elevation and 3d views.<BR /> <BR /> Thanks<BR /> <BR /> Todd</T></DIV> Tue, 23 May 2023 12:51:15 GMT https://community.graphisoft.com/t5/Modeling/join-lines-in-elevations-and-3d/m-p/190571#M103360 Anonymous 2023-05-23T12:51:15Z https://community.graphisoft.com/t5/Modeling/join-lines-in-elevations-and-3d/m-p/190572#M103361 If I understand what you are trying to do correctly, <BR /> Try going into your "wall selection settings" of the wall intersecting perpendicular and changing the "wall priority" by dragging the slider either way so it is a different value. This should clean up that line.<BR /> Hope that makes sense. Thu, 17 Mar 2011 01:42:19 GMT https://community.graphisoft.com/t5/Modeling/join-lines-in-elevations-and-3d/m-p/190572#M103361 Anonymous 2011-03-17T01:42:19Z