https://community.graphisoft.com/t5/Modeling/Insertion-Points-in-Morphs/m-p/196675#M106639 Morphs don't have insertion points as such.<BR /> Just surfaces, edges and nodes - but these nodes are not highlighted by hotspots.<BR /> The node you see on a morph is the one that is used to represent the base hieght of the morph.<BR /> I don't think you have any control over where it is.<BR /> <BR /> What you can do is to draw some lines on the bottom surface of your column base that intersect at the centre.<BR /> This will at least allow you to select that point to position copies of you morph.<BR /> <BR /> Or better still save the morph back as an object and you will get nodes at the bounding box and centre of the bounding box in 2D.<BR /> So if your morph is symetrical then the node will be in the centre.<BR /> If it is not symetrical you could open the object script and place a hotspot at the desired location in the 2D symbol.<BR /> <BR /> Barry. Tue, 25 Sep 2012 00:09:56 GMT Barry Kelly 2012-09-25T00:09:56Z https://community.graphisoft.com/t5/Modeling/Insertion-Points-in-Morphs/m-p/196674#M106638 <DIV class="actalk-migrated-content"><T>I've converted a column and baseplate to a morph. Now the insertion point is on the edge of the baseplate and not the center of the column. Is there a way to change to insertion point of a morph after it is made????</T></DIV> Wed, 24 May 2023 17:30:31 GMT https://community.graphisoft.com/t5/Modeling/Insertion-Points-in-Morphs/m-p/196674#M106638 drh64 2023-05-24T17:30:31Z https://community.graphisoft.com/t5/Modeling/Insertion-Points-in-Morphs/m-p/196675#M106639 Morphs don't have insertion points as such.<BR /> Just surfaces, edges and nodes - but these nodes are not highlighted by hotspots.<BR /> The node you see on a morph is the one that is used to represent the base hieght of the morph.<BR /> I don't think you have any control over where it is.<BR /> <BR /> What you can do is to draw some lines on the bottom surface of your column base that intersect at the centre.<BR /> This will at least allow you to select that point to position copies of you morph.<BR /> <BR /> Or better still save the morph back as an object and you will get nodes at the bounding box and centre of the bounding box in 2D.<BR /> So if your morph is symetrical then the node will be in the centre.<BR /> If it is not symetrical you could open the object script and place a hotspot at the desired location in the 2D symbol.<BR /> <BR /> Barry. Tue, 25 Sep 2012 00:09:56 GMT https://community.graphisoft.com/t5/Modeling/Insertion-Points-in-Morphs/m-p/196675#M106639 Barry Kelly 2012-09-25T00:09:56Z