topic Re: Wall slant in Modeling

Wall slant

Anonymous — Wed, 24 May 2023 11:02:25 GMT

I would like to taper a curved wall from top to bottom in Archicad 15. This would be similar to an inverted cone surface unwraped to an arc. Thanks.

Re: Wall slant

Dwight — Mon, 07 Nov 2011 00:05:00 GMT

Without being a workaround apologist or anything, for now, use a curved ramp to trim the wall with a Solid Element Operation.

Re: Wall slant

Anonymous — Mon, 07 Nov 2011 01:19:00 GMT

Thanks for the info. I didn't explain myself very well. I would like to taper the sides of a wall. Not the top like a ramp. The top of the wall would be the original width and the bottom of the wall would taper inwards creating a narrower footprint than the original. I'll try to use a roof element on each side and trim to the bottom and see if that works. Thanks again.

Re: Wall slant

Eduardo Rolon — Mon, 07 Nov 2011 01:31:06 GMT

Is this what you are looking for?

Re: Wall slant

Eduardo Rolon — Mon, 07 Nov 2011 01:31:42 GMT

Curve example 01

Re: Wall slant

Eduardo Rolon — Mon, 07 Nov 2011 01:32:10 GMT

Curve example 02

Re: Wall slant

Eduardo Rolon — Mon, 07 Nov 2011 01:33:44 GMT

or with a custom profile