https://community.graphisoft.com/t5/Modeling/INTERNAL-CUT-ERROR-54-and-64/m-p/205617#M111358 <DIV class="actalk-migrated-content"><T>Hi everyone, <BR /> does anyone knows what does this means?<BR /> <BR /> I got it every time i open the 3D window and some sections / elevations. <BR /> <BR /> the markers are OK, it shows the little window like 200 times but finally it does the section or the 3D view, but its annoying.<BR /> <BR /> How can i correct this?<BR /> <BR /> Thanks in advance..<BR /> Nando</T></DIV> Fri, 26 May 2023 12:44:20 GMT Nando Mogollon 2023-05-26T12:44:20Z https://community.graphisoft.com/t5/Modeling/INTERNAL-CUT-ERROR-54-and-64/m-p/205617#M111358 <DIV class="actalk-migrated-content"><T>Hi everyone, <BR /> does anyone knows what does this means?<BR /> <BR /> I got it every time i open the 3D window and some sections / elevations. <BR /> <BR /> the markers are OK, it shows the little window like 200 times but finally it does the section or the 3D view, but its annoying.<BR /> <BR /> How can i correct this?<BR /> <BR /> Thanks in advance..<BR /> Nando</T></DIV> Fri, 26 May 2023 12:44:20 GMT https://community.graphisoft.com/t5/Modeling/INTERNAL-CUT-ERROR-54-and-64/m-p/205617#M111358 Nando Mogollon 2023-05-26T12:44:20Z https://community.graphisoft.com/t5/Modeling/INTERNAL-CUT-ERROR-54-and-64/m-p/205618#M111359 stepsearch and find.<BR /> <BR /> When I got problems similar to this, I turn off all layers, turn one on, check 3d mode (maybe on floor at a time too). If I got error, then go to 2d view, step through all objects on that layer and see if there are somethin that look weird. Wed, 05 Nov 2008 10:23:26 GMT https://community.graphisoft.com/t5/Modeling/INTERNAL-CUT-ERROR-54-and-64/m-p/205618#M111359 Anonymous 2008-11-05T10:23:26Z