topic good ol' walls corner joint (ac12) in Modeling

good ol' walls corner joint (ac12)

Anonymous — Wed, 24 May 2023 11:00:23 GMT

hi,
i'm trying to properly join the walls in the corner of an air supply shaft in the basement.
the walls are not of the same kind: one has a 24cm concrete core, the other one 25cm.
all other parameters match: the components number, their priorities, the wall heights, the wall priorities, the end caps, the reference lines, everything.

but the walls still won't join as they should - the components intersect.
both core components have a priority 10, the thermal insulations 8. we've tried 14 and 6, then both 10, still to no avail.

what's that i'm missing?
thanks in advance for any clue.

rob

Re: good ol' walls corner joint (ac12)

Anonymous — Mon, 16 Jan 2012 13:29:10 GMT

No problems in my example (AC14).
1. Check the position of the reference lines in your walls.
2. Niche opening 110/249 (2D or 3D)?. Maybe it interferes with the walls.

Re: good ol' walls corner joint (ac12)

Anonymous — Mon, 16 Jan 2012 13:52:37 GMT

thanks andro for your suggestion, we've checked that option previously. the niche is already in another wall, without a thermal insulation. and yes, everything's in 3d.

in the meantime it turned out the adjacent thermal insulation (dashed grey line) caused the inconsistency. moving it a bit from the wall renders the corner joint fine.
thanks again,

rob