https://community.graphisoft.com/t5/Modeling/3d-will-NOT-WORK/m-p/218533#M118650 <BLOCKQUOTE>Archimamamia wrote:<BR />...am modeling a building built in 1912; three story w/basement. wanted to show 3d Sections 2 (North/South) and 2 (East/West)...the East/West came out fine, when I run the Heavy line Marquee along the North/south section lines...it won't generate a picvture...tried for both directions../.NADA...<BR /> <BR /> WHY if it works from East and West...will it not work North/south....<BR /> <BR /> ...also, this morning, got to watch the AC18 Top bar, where the file, edit, view, design, document.etc are located, go through a blinking phase that lasted over a minute....<BR /> <BR /> AC18 w/all updates.</BLOCKQUOTE> I suspect this is going to be one for tech support. Wed, 03 Aug 2016 22:59:14 GMT Richard Morrison 2016-08-03T22:59:14Z https://community.graphisoft.com/t5/Modeling/3d-will-NOT-WORK/m-p/218532#M118649 <DIV class="actalk-migrated-content"><T>...am modeling a building built in 1912; three story w/basement. wanted to show 3d Sections 2 (North/South) and 2 (East/West)...the East/West came out fine, when I run the Heavy line Marquee along the North/south section lines...it won't generate a picvture...tried for both directions../.NADA...<BR /> <BR /> WHY if it works from East and West...will it not work North/south....<BR /> <BR /> ...also, this morning, got to watch the AC18 Top bar, where the file, edit, view, design, document.etc are located, go through a blinking phase that lasted over a minute....<BR /> <BR /> AC18 w/all updates.</T></DIV> Wed, 03 Aug 2016 19:40:38 GMT https://community.graphisoft.com/t5/Modeling/3d-will-NOT-WORK/m-p/218532#M118649 Anonymous 2016-08-03T19:40:38Z https://community.graphisoft.com/t5/Modeling/3d-will-NOT-WORK/m-p/218533#M118650 <BLOCKQUOTE>Archimamamia wrote:<BR />...am modeling a building built in 1912; three story w/basement. wanted to show 3d Sections 2 (North/South) and 2 (East/West)...the East/West came out fine, when I run the Heavy line Marquee along the North/south section lines...it won't generate a picvture...tried for both directions../.NADA...<BR /> <BR /> WHY if it works from East and West...will it not work North/south....<BR /> <BR /> ...also, this morning, got to watch the AC18 Top bar, where the file, edit, view, design, document.etc are located, go through a blinking phase that lasted over a minute....<BR /> <BR /> AC18 w/all updates.</BLOCKQUOTE> I suspect this is going to be one for tech support. Wed, 03 Aug 2016 22:59:14 GMT https://community.graphisoft.com/t5/Modeling/3d-will-NOT-WORK/m-p/218533#M118650 Richard Morrison 2016-08-03T22:59:14Z