topic Re: problem at wall corner in Modeling

problem at wall corner

Anonymous — Tue, 09 May 2023 13:48:14 GMT

Hello,
When I draw wall enclosure:
(1) whilst when draw wall enclosure on a blank space, it fillets normally.
(2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply,
Please advice why, see picture above

Also, when I draw an internal wall which attached to the external wall, an unwanted extension part appears, please advice why, see picture below
Thanks

Re: problem at wall corner

Christophe Fortineau — Sun, 15 Nov 2020 16:58:07 GMT

emailcopy wrote:
whilst when draw wall enclosure on a blank space, it fillets normally.

There is something in your model which prevents the correct connection between the two walls: a column on a hidden layer, another wall on a higher level (plumb), or a slab or a ground mesh with too high a material priority.

emailcopy wrote:
(2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply,
Please advice why, see picture above

I do not understand this message 😕 but I think it is a material priority subject.

Re: problem at wall corner

Anonymous — Mon, 16 Nov 2020 01:51:40 GMT

Christophe wrote:

emailcopy wrote:
(2) but when draw based on the basement trace reference plan, the wall corner cannot be filleted sharply,
Please advice why, see picture above
I do not understand this message 😕 but I think it is a material priority subject.

That means: (1) is the footing at storey of "foundation" , drawn based on the trace reference of "ground floor". Then the wall corner fillet not completed.
(2) is the footing but drawn NOT on the trace reference storey, which wall corner is filleted perfectly
---- this different fillet result could be the effect by trace reference ?

Re: problem at wall corner

Lingwisyer — Mon, 16 Nov 2020 01:55:39 GMT

Does it fillet properly if you manually adjust the reference lines so that they meet each other? ctrl + i.

Re: problem at wall corner

Anonymous — Mon, 16 Nov 2020 02:16:11 GMT

Lingwisyer wrote:
Does it fillet properly if you manually adjust the reference lines so that they meet each other? ctrl + i.

Tried but seems no way to adjust manually...
and what is the reason why unable to fillet completely automatically

Re: problem at wall corner

Lingwisyer — Mon, 16 Nov 2020 03:03:23 GMT

Suspend groups (alt + g), select two of the walls and intersect (ctrl + i)

Ling.

Re: problem at wall corner

Anonymous — Mon, 16 Nov 2020 04:31:40 GMT

done, thanks Ling,
if possible I want to know the reason why cannot fillet automatically....

Thanks

Re: problem at wall corner

Barry Kelly — Mon, 16 Nov 2020 06:29:26 GMT

emailcopy wrote:
done, thanks Ling,
if possible I want to know the reason why cannot fillet automatically....

Thanks

The second wall you draw will automatically snap and trim to the first wall, but it will not adjust the length of the first wall.

Barry.

Re: problem at wall corner

Lingwisyer — Mon, 16 Nov 2020 06:53:07 GMT

When drawing a continuous wall, it might be a good idea to change your building method to chained or in you current case rectangular. Less opportunity to miss align your connections then.