https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225790#M121617 <DIV class="actalk-migrated-content"><R>Hi guys, I'm pretty new to this program and I'm having a problem with inclined/sloped walls. <BR /> <BR /> <BR /> The concrete wall is already a bit inclined and I need the top part of it to be cut off just like the inclination of the black wall.<BR /> <BR /> Is there a way to edit the wall not using morph / SEO?</R></DIV> Tue, 09 May 2023 13:47:58 GMT Anonymous 2023-05-09T13:47:58Z https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225790#M121617 <DIV class="actalk-migrated-content"><R>Hi guys, I'm pretty new to this program and I'm having a problem with inclined/sloped walls. <BR /> <BR /> <BR /> The concrete wall is already a bit inclined and I need the top part of it to be cut off just like the inclination of the black wall.<BR /> <BR /> Is there a way to edit the wall not using morph / SEO?</R></DIV> Tue, 09 May 2023 13:47:58 GMT https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225790#M121617 Anonymous 2023-05-09T13:47:58Z https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225791#M121618 A wall can incline at an angle - i.e it does not have to be vertical.<BR /> <BR /> However it can not slope from end to end - i.e. one end lower than the other.<BR /> To do that you must trim (connect) it to a roof or shell, or perform a Solid Element Operation t cut away the part you do not need.<BR /> <BR /> <BR /> Barry. Wed, 25 Nov 2020 04:02:48 GMT https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225791#M121618 Barry Kelly 2020-11-25T04:02:48Z https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225792#M121619 Hope they had an easier way to edit walls... I'll use the SEO to cut it then. Thanks Barry! Wed, 25 Nov 2020 04:57:27 GMT https://community.graphisoft.com/t5/Modeling/Inclined-wall/m-p/225792#M121619 Anonymous 2020-11-25T04:57:27Z