https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231094#M123926 Rob, AFAIK you can't. I have struggled with this one too. I believe the problem is that AC just sees the opening as a door type object.<BR /> <BR /> A work around would be to end the walls on both sides of the opening and put in a separate header piece of wall above which you could set to show as overhead only with dashed lines. You will have to flip the reference line of the overhead piece of wall or it will not play nice.<BR /> <BR /> Cheers, Fri, 12 Dec 2014 15:49:16 GMT Gerald Hoffman 2014-12-12T15:49:16Z https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231093#M123925 <DIV class="actalk-migrated-content"><T>see attached.</T></DIV><BR /><IMG src="http://community.graphisoft.com/t5/image/serverpage/image-id/69328iA5502C61589466E0/image-size/large?v=v2&amp;px=999" border="0" alt="WRAP-AROUND-DRYWALL-OPENINGS.jpg" title="WRAP-AROUND-DRYWALL-OPENINGS.jpg" /> Thu, 25 May 2023 15:57:04 GMT https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231093#M123925 rob2218 2023-05-25T15:57:04Z https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231094#M123926 Rob, AFAIK you can't. I have struggled with this one too. I believe the problem is that AC just sees the opening as a door type object.<BR /> <BR /> A work around would be to end the walls on both sides of the opening and put in a separate header piece of wall above which you could set to show as overhead only with dashed lines. You will have to flip the reference line of the overhead piece of wall or it will not play nice.<BR /> <BR /> Cheers, Fri, 12 Dec 2014 15:49:16 GMT https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231094#M123926 Gerald Hoffman 2014-12-12T15:49:16Z https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231095#M123927 well.....VIOLA! (sp?) I just found out from a good friend in the north east coast....you can.<BR /> Here's how.<BR /> you have to use a different opening object other than "Simple opening"<BR /> it appears theres an opening type which "does" indeed allow you to set wrap around drywall closure sizes....very slick. Fri, 12 Dec 2014 16:33:11 GMT https://community.graphisoft.com/t5/Modeling/Openings-How-to-get-drywal-to-wrap-around/m-p/231095#M123927 rob2218 2014-12-12T16:33:11Z