https://community.graphisoft.com/t5/Modeling/Floor-Plan-Cut-Plane/m-p/234187#M125287 Does overlaying two separate plans in a layout do what you want?<BR /> <BR /> Barry. Tue, 03 Oct 2017 08:28:01 GMT Barry Kelly 2017-10-03T08:28:01Z https://community.graphisoft.com/t5/Modeling/Floor-Plan-Cut-Plane/m-p/234186#M125286 <DIV class="actalk-migrated-content"><T>I am sure this has been asked before. I am working a simple foundation. I want to show part next story up so my foundation shows the walls with door openings but with a dashed line. <BR /> I start with the 1st floor plan view.<BR /> I go into the Floor Plan Cut Plane under Documenting Tools and enter in Relative <BR /> Floor Plan Range .<BR /> Show up to: Current story, offset by 5'.<BR /> Show down to: Current story, offset by -1'<BR /> <BR /> and then Absolute Display Limit: Project Zero, -1'<BR /> <BR /> ...thinking this will allow me to show the walls and openings of the 1st story on the Foundation. It should work but I must be doing something wrong.<BR /> <BR /> I always want to do this but I have just bypassed it to save time since it is already on another plan.<BR /> <BR /> Any Suggestions to accomplish this?</T></DIV> Wed, 24 May 2023 10:40:41 GMT https://community.graphisoft.com/t5/Modeling/Floor-Plan-Cut-Plane/m-p/234186#M125286 Anonymous 2023-05-24T10:40:41Z https://community.graphisoft.com/t5/Modeling/Floor-Plan-Cut-Plane/m-p/234187#M125287 Does overlaying two separate plans in a layout do what you want?<BR /> <BR /> Barry. Tue, 03 Oct 2017 08:28:01 GMT https://community.graphisoft.com/t5/Modeling/Floor-Plan-Cut-Plane/m-p/234187#M125287 Barry Kelly 2017-10-03T08:28:01Z