topic Re: Doors not Showing in plan view in Modeling

Doors not Showing in plan view

Anonymous — Wed, 24 May 2023 06:36:57 GMT

Hi,

Im very new to ArchiCAD and having some issues with the display of doors in my plan view.

In 3D they are all visible where I placed them however I have just noticed they are not showing up in plan. There is a just a solid wall where they should be.

My floor section cut is set to 1150, im not sure what else to check to make them visible again.

Thanks

Re: Doors not Showing in plan view

Barry Kelly — Mon, 10 Oct 2016 01:36:10 GMT

Check the Model View Options.
If that is not it then look at Renovation Filters.

Barry.

Re: Doors not Showing in plan view

Anonymous — Mon, 10 Oct 2016 06:36:18 GMT

Thanks for your help,

after a couple of hours of pain i have figured out my solution.

I had changed the settings of my walls under "Floor Plan Display" and made them outline only, I switched this over to 'symbolic cut' and I have doors again!

Thanks again,
Ben

Re: Doors not Showing in plan view

Barry Kelly — Mon, 10 Oct 2016 06:39:43 GMT

Beno_52 wrote:
I had changed the settings of my walls under "Floor Plan Display" and made them outline only, I switched this over to 'symbolic cut' and I have doors again!

That would have been my third guess.

Barry.

Re: Doors not Showing in plan view

Anonymous — Fri, 26 Apr 2019 23:14:09 GMT

hi!

im using archicad 21, and having the same problem, although i tried all 3 options you guys mentioned, none of them worked for me. any ideas what else i could do?

thanks in advance

E

Re: Doors not Showing in plan view

Anonymous — Fri, 26 Apr 2019 23:18:48 GMT

update: its not working with the windows either, but they both show up on my 3D

Re: Doors not Showing in plan view

Barry Kelly — Mon, 29 Apr 2019 02:33:20 GMT

EszterS wrote:
im using archicad 21, and having the same problem, although i tried all 3 options you guys mentioned, none of them worked for me. any ideas what else i could do?

Make sure that both the plan and elevation views really are using the same MVO combination and renovation filters.
If you are sure that they are OK then check that the walls have a "Symbolic" floor plan display as well as the actual doors and windows.

Barry.

Re: Doors not Showing in plan view

Anonymous — Thu, 09 Jul 2020 17:47:39 GMT

"This element is inactive in this view" ..that was the message shown on clicking a half visible door in plan. Then figured out I had messed the display order and the beams below my slab were showing front mot, thus disabling my doors a proper display.

Re: Doors not Showing in plan view

brunobarretti — Wed, 23 Mar 2022 23:29:14 GMT

Oh man that happened to me too and stressed me out a lot but you helped me and saved me a lot of time. THANK you so much!