topic Re: Problem joining three walls when one is angled? in Modeling

Problem joining three walls when one is angled?

Ivan Myers — Wed, 24 May 2023 06:35:37 GMT

Hi I have a problem occasionally when joining three wall. It always seems to happen when one is at an angle, I can never seem to get the third to display properly and it especially happens when I'm trying to connect at the angled joint. See picture below. Thanks, and sorry if this was already answered in a prior thread.

Re: Problem joining three walls when one is angled?

Laszlo Nagy — Fri, 25 Nov 2016 12:13:30 GMT

Make sure that the reference line of the horizontal wall is at its top on the image, and the reference line of the diagonal wall is at its right side on the image.

Re: Problem joining three walls when one is angled?

Ivan Myers — Fri, 25 Nov 2016 19:33:31 GMT

Thank you Laszlo you quickly becoming my ArhciCAD Mentor and hero!
That was the problem.

Regards,
Ivan

Re: Problem joining three walls when one is angled?

Laszlo Nagy — Tue, 29 Nov 2016 10:25:58 GMT

Thanks