topic Re: Question about a door reveal in Modeling

Question about a door reveal

Anonymous — Tue, 09 May 2023 13:51:38 GMT

How I make this door reveal seamless? The point is I cannot do it through the door settings and the only way I came up with is to do it by adding extra walls but since it's a door opening the extra pieces of wall cannot be intersected seamlessly.

Re: Question about a door reveal

Christophe Fortineau — Wed, 01 Jul 2020 11:45:47 GMT

Hello anto_bg,

Did you try to use bash option into door parameters ?

Re: Question about a door reveal

Anonymous — Wed, 01 Jul 2020 13:23:12 GMT

Hello Christophe,

I tried but it can be applied to the other side of the wall only (next to the door). ¯\_(ツ)_/¯ There is an arch in front of the door that I need to show in 2D in some way. The door itself opens inwards because it is a century-old house and we cannot change it.

Re: Question about a door reveal

Christophe Fortineau — Wed, 01 Jul 2020 13:49:43 GMT

You are able to put two doors at the same place.

Re: Question about a door reveal

Anonymous — Wed, 01 Jul 2020 18:53:16 GMT

Actually I managed to do it by adding the door once again to the wall but this time - in the opposite direction. I set the reveal and then I flipped the door. Luckily the reveal remained where it was.