topic Re: Grabbing the "LollyPop" (reference bubble) in Modeling

Grabbing the "LollyPop" (reference bubble)

rob2218 — Thu, 26 Mar 2015 16:39:09 GMT

see attached.

Re: Grabbing the "LollyPop" (reference bubble)

Dontknow — Fri, 27 Mar 2015 08:12:54 GMT

As long as you keep your mouse on the object the lollypop will show up.
So move your mouse over the object to the lollypop.
After that you can select the lollypop.
A good mouse helps a lot.

Re: Grabbing the "LollyPop" (reference bubble)

Link — Fri, 27 Mar 2015 14:22:22 GMT

You can always hit Q to force a guideline?

Cheers,
Link.

Re: Grabbing the "LollyPop" (reference bubble)

rob2218 — Fri, 27 Mar 2015 21:37:00 GMT

Understood....as I drag the mouse "OVER" the object, whether it be a line, wall, whatevs, the lolly-pop stays..but..sometimes when I go to actually perform the "selection of the lolly-pop ref bubble"...then I end up selectign the object underneath which it was making reference to to create that lollypop....it's a bit of a "hit or miss" kinda thingy.

Dontknow wrote:
As long as you keep your mouse on the object the lollypop will show up.
So move your mouse over the object to the lollypop.
After that you can select the lollypop.
A good mouse helps a lot.

Re: Grabbing the "LollyPop" (reference bubble)

Dontknow — Sat, 28 Mar 2015 08:37:56 GMT

When you want to pick up the 'lollypop' click on it on the left or right side of the object and don't release your mouse-click.