https://community.graphisoft.com/t5/Modeling/Cursor-does-not-select-wall-corners-when-drawing-zones/m-p/258894#M135896 <DIV class="actalk-migrated-content"><T>I have been drawing zones inside rooms and everything functioned as it should. However, I wonder if I may have inadvertently changed a setting because the cursor "suddenly" no longer selects room corners. There is now a small grey dot slightly removed from the cursor and the zone is drawn from this grey dot, not from the end point of the cursor. What did I do?</T></DIV> Wed, 24 May 2023 06:42:53 GMT Anonymous 2023-05-24T06:42:53Z https://community.graphisoft.com/t5/Modeling/Cursor-does-not-select-wall-corners-when-drawing-zones/m-p/258894#M135896 <DIV class="actalk-migrated-content"><T>I have been drawing zones inside rooms and everything functioned as it should. However, I wonder if I may have inadvertently changed a setting because the cursor "suddenly" no longer selects room corners. There is now a small grey dot slightly removed from the cursor and the zone is drawn from this grey dot, not from the end point of the cursor. What did I do?</T></DIV> Wed, 24 May 2023 06:42:53 GMT https://community.graphisoft.com/t5/Modeling/Cursor-does-not-select-wall-corners-when-drawing-zones/m-p/258894#M135896 Anonymous 2023-05-24T06:42:53Z https://community.graphisoft.com/t5/Modeling/Cursor-does-not-select-wall-corners-when-drawing-zones/m-p/258895#M135897 Sounds like you have turned Snap on. Just hit the 'S' key to toggle it on and off.<BR /> <BR /> Also, if you use the Magic Wand (spacebar) you don't have to select rooms corner by corner. Just hold down the spacebar and click within the room. Sun, 14 Feb 2016 19:27:12 GMT https://community.graphisoft.com/t5/Modeling/Cursor-does-not-select-wall-corners-when-drawing-zones/m-p/258895#M135897 Anonymous 2016-02-14T19:27:12Z