https://community.graphisoft.com/t5/Modeling/fill-tool-not-match-spline/m-p/261083#M136851 A fill boundary is only made up of arcs and straight lines, it will try to follow the spline using arcs which will inevitably lead to minor deviations from the spline path. Your Magic Wand setting will impact on the degree of deviation, but never eliminate it. Wed, 21 Apr 2021 11:39:16 GMT DGSketcher 2021-04-21T11:39:16Z https://community.graphisoft.com/t5/Modeling/fill-tool-not-match-spline/m-p/261082#M136850 <DIV class="actalk-migrated-content"><T>hello,<BR /> I drew a close area including spline, then use fill tool to fill, but the fill area has a little bit discrepency with the spline, which is not so accurate in terms of fine art line.<BR /> <BR /> Please advice<BR /> Regards</T></DIV> Wed, 21 Apr 2021 10:08:21 GMT https://community.graphisoft.com/t5/Modeling/fill-tool-not-match-spline/m-p/261082#M136850 Anonymous 2021-04-21T10:08:21Z https://community.graphisoft.com/t5/Modeling/fill-tool-not-match-spline/m-p/261083#M136851 A fill boundary is only made up of arcs and straight lines, it will try to follow the spline using arcs which will inevitably lead to minor deviations from the spline path. Your Magic Wand setting will impact on the degree of deviation, but never eliminate it. Wed, 21 Apr 2021 11:39:16 GMT https://community.graphisoft.com/t5/Modeling/fill-tool-not-match-spline/m-p/261083#M136851 DGSketcher 2021-04-21T11:39:16Z