topic Re: AC 22 Vectorial Hatching Doesn't Appear in Elevations and Sections in Modeling

AC 22 Vectorial Hatching Doesn't Appear in Elevations and Sections

EH21 — Tue, 09 May 2023 13:43:42 GMT

New issue on AC22. See images. This example is for an exterior wall, but it is happening with roofs and slabs as well.

When the exterior surface is defined, the vectorial hatching (which should appear as shingles) will only appear on sections and elevations when the wall end or roof side material is also defined as the same material. However, when the end material is changed, it also makes the vectorial hatching associated with the exterior material appear on the interior.

No graphic overrides are set, and I've gone through every setting I can think of.

Help!!

Re: AC 22 Vectorial Hatching Doesn't Appear in Elevations and Sections

Podolsky — Sun, 16 May 2021 12:18:43 GMT

I guess here only two options: first, this is a bug (but I never experienced it); second - your wall is set the way, that exterior surface is inside and interior - outside. Flip the wall - maybe it will work then.

Re: AC 22 Vectorial Hatching Doesn't Appear in Elevations and Sections

EH21 — Tue, 01 Jun 2021 20:08:50 GMT

Thank you! I did manage to figure out the issue. The section view settings were only set to view the core elements and not the finish surfaces of the walls.

Re: AC 22 Vectorial Hatching Doesn't Appear in Elevations and Sections

Barry Kelly — Wed, 02 Jun 2021 01:48:07 GMT

EH21 wrote:
Thank you! I did manage to figure out the issue. The section view settings were only set to view the core elements and not the finish surfaces of the walls.

Thanks for posting back with the solution.

Barry.