https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270701#M141069 Perfect! Exactly what I needed, thanks! Tue, 12 Nov 2019 15:01:03 GMT Bill 2019-11-12T15:01:03Z https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270699#M141067 <DIV class="actalk-migrated-content"><T>I am trying to create a typical basement-type stair, where the wood treads sit on top of the wood stringers. I cannot figure out in the stair tool how to create this... when I set up the stair, the only option I see for stringers is for them to be located on the sides of the stair, and the treads are set into the sides. What am i missing? Is there a setting to offset the stringer locations?<BR /> <BR /> Thanks!</T></DIV> Thu, 25 May 2023 14:39:46 GMT https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270699#M141067 Bill 2023-05-25T14:39:46Z https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270700#M141068 Instead of the 'Stringer" flight/landing, try using the 'Beam' type.<BR /> The beam sits under the treads, and you can use the 'Open Stringer 22' beam.<BR /> <BR /> Barry. Tue, 12 Nov 2019 01:04:28 GMT https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270700#M141068 Barry Kelly 2019-11-12T01:04:28Z https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270701#M141069 Perfect! Exactly what I needed, thanks! Tue, 12 Nov 2019 15:01:03 GMT https://community.graphisoft.com/t5/Modeling/How-to-move-stair-stringers-in/m-p/270701#M141069 Bill 2019-11-12T15:01:03Z