https://community.graphisoft.com/t5/Modeling/polyline-for-shell-tool/m-p/273051#M142033 <DIV class="actalk-migrated-content"><T>Hello,<BR /> I want to make a shell at two ends of curves, but only spline can make it (but spline seems unable to draw straight line),<BR /> how can I use other line tools (pline, fill etc) to make shell?<BR /> <BR /> PS now I used morph fro one end to the other, then drag point by point (not a direct way)<BR /> regards</T></DIV> Wed, 24 May 2023 16:59:52 GMT Anonymous 2023-05-24T16:59:52Z https://community.graphisoft.com/t5/Modeling/polyline-for-shell-tool/m-p/273051#M142033 <DIV class="actalk-migrated-content"><T>Hello,<BR /> I want to make a shell at two ends of curves, but only spline can make it (but spline seems unable to draw straight line),<BR /> how can I use other line tools (pline, fill etc) to make shell?<BR /> <BR /> PS now I used morph fro one end to the other, then drag point by point (not a direct way)<BR /> regards</T></DIV> Wed, 24 May 2023 16:59:52 GMT https://community.graphisoft.com/t5/Modeling/polyline-for-shell-tool/m-p/273051#M142033 Anonymous 2023-05-24T16:59:52Z https://community.graphisoft.com/t5/Modeling/polyline-for-shell-tool/m-p/273052#M142034 Some thoughts about this question and the shell-Tool: <BR /> <BR /> <IFRAME width="640" height="360" src="https://www.youtube.com/embed/orgxLw0bBfg" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen=""></IFRAME><BR /> <BR /> <BR /> and an recommendation about workflow-speed in Archicad with huge ammounts of complex shapes: Always make GDL-Library-parts of it - they react much faster in Archicad than the original shapes of the Archicad-tools.<BR /> <BR /> a test:<BR /> <BR /> <IFRAME width="640" height="360" src="https://www.youtube.com/embed/PtvY_6qr70A" frameborder="0" allow="accelerometer; autoplay; clipboard-write; encrypted-media; gyroscope; picture-in-picture" allowfullscreen=""></IFRAME> Tue, 08 Jun 2021 04:40:09 GMT https://community.graphisoft.com/t5/Modeling/polyline-for-shell-tool/m-p/273052#M142034 Hmooslechner 2021-06-08T04:40:09Z