topic Re: Beam Corners are not mending in 2D, Why? in Modeling

Beam Corners are not mending in 2D, Why?

4hotshoes — Fri, 26 May 2023 10:26:20 GMT

I have never seen the beam tool not mend corners and intersections. Is there a setting that controls this? See image. They mend fine in 3D.

Re: Beam Corners are not mending in 2D, Why?

Barry Kelly — Thu, 21 Nov 2019 00:51:13 GMT

Have a look at the layer Intersection Priority number (in the layer settings) of the layer that the beams are in.
Is it set to 0 (zero)?

If so the beams will not trim.
It could be that you are using a different layer combination in plan and 3D - the IP number for each layer is saved with the layer combination.

Barry.

Re: Beam Corners are not mending in 2D, Why?

David Maudlin — Thu, 21 Nov 2019 13:28:21 GMT

Todd:

Also check your On-Screen Display Options > Clean Wall & Beam Intersections.

David