topic Re: problem: how can we add a composite to the side faces of the slab? in Modeling

problem: how can we add a composite to the side faces of the slab?

aryastark — Thu, 25 May 2023 15:33:30 GMT

valar morhgulis,

i want to add composites side face of the slab. how can i?

++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++

Re: problem: how can we add a composite to the side faces of the slab?

Lingwisyer — Thu, 27 Aug 2020 01:26:13 GMT

Use a Complex Profile beam?

Re: problem: how can we add a composite to the side faces of the slab?

Barry Kelly — Thu, 27 Aug 2020 02:13:53 GMT

Slabs can't have composite end profiles.

Because you want to wrap it underneath slightly, it will be easiest to add a wall or beam composite as suggested by Ling.
Or if it just in a section and doesn't need to be modelled, you can just add some lines (although I don't like adding 2D lines if it can be avoided).

If it was just down the edge of the slab, you could add a modifier to the wall composite to allow you to stretch just the membrane skin down (but not wrap it underneath).

Barry.

Re: problem: how can we add a composite to the side faces of the slab?

aryastark — Thu, 27 Aug 2020 18:38:16 GMT

thanks.

if there are other people in need of information around can watch this-> https://youtu.be/96p6qKMRucg

If it was just down the edge of the slab, you could add a modifier to the wall composite to allow you to stretch just the membrane skin down (but not wrap it underneath).

I didn't know we could modify the layers one by one.

furher watching for this advice -> https://www.youtube.com/playlist?list=PLnXY6vLUwlWUJmDnD8UGZKPyR9tm4ge8H