topic Orientation and snapping point 0.006 degrees WRONG in Modeling

Orientation and snapping point 0.006 degrees WRONG

Anonymous — Sat, 26 Jan 2019 15:04:01 GMT

This comes up with the norwegian template, it also snaps to this degree and it is making me nuts! Is there any way to change this? Pic highly related.

This is a newly creadted document, not a single line drawn yet. what is going on??

Re: Orientation and snapping point 0.006 degrees WRONG

agroni — Sat, 26 Jan 2019 20:51:31 GMT

Usualy these angles are there when you already have drawn components with those specific angles.
Are you opening the new file with your template, or the archicad one?
If you have a custom template, I would suggest to check it there...

Re: Orientation and snapping point 0.006 degrees WRONG

Barry Kelly — Tue, 29 Jan 2019 02:40:53 GMT

These are just screen orientations that have been set previously.
They won't be used (or snapped to) if you have it set to 0° as in your image.

I don't know of any way to delete these unwanted angles from the list.

If elements are snapping to odd angles when your screen orientation is 0°, then you will want to look at the rotated grid settings.
You may be using a slightly rotated grid rather than the square one.

Barry.

Re: Orientation and snapping point 0.006 degrees WRONG

Richard Morrison — Tue, 29 Jan 2019 17:22:18 GMT

Barry wrote:
I don't know of any way to delete these unwanted angles from the list.

When you save a custom rotation angle, it just bumps one off the list.