topic Re: Molding in a Barel Vault ceiling in Modeling

Molding in a Barel Vault ceiling

Anonymous — Fri, 06 May 2016 15:06:04 GMT

Hi! there are any library parts or any method to create a curved molding in a barrel vault?
Thanks

Re: Molding in a Barel Vault ceiling

Erich — Sat, 07 May 2016 03:30:53 GMT

What type of molding are you looking to make? You could try using walls or beams to make the curved part in plan. Then convert to Morphs and rotate up into position.

GDL also offers a means to do this. That is what I ultimately used in response to a similar question I had a while ago (AC 11 or so): Plaster pattern on a barrel vaulted ceiling

Re: Molding in a Barel Vault ceiling

Anonymous — Sat, 07 May 2016 20:48:00 GMT

Thanks, it will be kind of data molding in the molding schedule I will define the Profile.
But I will definaly give a look at your post.
Thanks

Re: Molding in a Barel Vault ceiling

Erich — Sat, 07 May 2016 21:22:19 GMT

Since I didn't have the Morph tool at the time, it was a much more difficult proposition.