https://community.graphisoft.com/t5/Modeling/Editing-a-mesh/m-p/288917#M149231 If the nodes are all on the same ridge you can tick the "Apply to all" check box and all nodes on that ridge will change.<BR /> <BR /> Otherwise you can only change one node at a time.<BR /> <BR /> The pet palette should remember the last operation (i.e. z height) used - so long as you don't press cancel.<BR /> <BR /> Barry. Fri, 04 May 2018 08:13:44 GMT Barry Kelly 2018-05-04T08:13:44Z https://community.graphisoft.com/t5/Modeling/Editing-a-mesh/m-p/288916#M149230 <DIV class="actalk-migrated-content"><T>I am happy with the mesh tool of archicad. I would like to ask if there is a way that I can edit the height of several points at a time or unless editing one by one but not having to press the "z" icon again in the tools palette once I changed the coordinate in a point.</T></DIV> Thu, 25 May 2023 14:54:17 GMT https://community.graphisoft.com/t5/Modeling/Editing-a-mesh/m-p/288916#M149230 Anonymous 2023-05-25T14:54:17Z https://community.graphisoft.com/t5/Modeling/Editing-a-mesh/m-p/288917#M149231 If the nodes are all on the same ridge you can tick the "Apply to all" check box and all nodes on that ridge will change.<BR /> <BR /> Otherwise you can only change one node at a time.<BR /> <BR /> The pet palette should remember the last operation (i.e. z height) used - so long as you don't press cancel.<BR /> <BR /> Barry. Fri, 04 May 2018 08:13:44 GMT https://community.graphisoft.com/t5/Modeling/Editing-a-mesh/m-p/288917#M149231 Barry Kelly 2018-05-04T08:13:44Z