https://community.graphisoft.com/t5/Modeling/Wall-problem/m-p/290341#M149980 <DIV class="actalk-migrated-content"><R>Hello everybody!<BR /> <BR /> I am trying to figure out how to extend a concrete wall to the first red line. The concrete hatch needs to be over the insulation hatch. The concrete wall has to ignore the facade wall and end just end in the middle of the composite wall.<BR /> </R></DIV> Wed, 24 May 2023 06:22:10 GMT Anonymous 2023-05-24T06:22:10Z https://community.graphisoft.com/t5/Modeling/Wall-problem/m-p/290341#M149980 <DIV class="actalk-migrated-content"><R>Hello everybody!<BR /> <BR /> I am trying to figure out how to extend a concrete wall to the first red line. The concrete hatch needs to be over the insulation hatch. The concrete wall has to ignore the facade wall and end just end in the middle of the composite wall.<BR /> </R></DIV> Wed, 24 May 2023 06:22:10 GMT https://community.graphisoft.com/t5/Modeling/Wall-problem/m-p/290341#M149980 Anonymous 2023-05-24T06:22:10Z https://community.graphisoft.com/t5/Modeling/Wall-problem/m-p/290342#M149981 I'm assuming the exterior wall is a composite. If the concrete <I></I><S><I><I></I></I></S>Building Material<E></E> has a higher <I></I><S><I><I></I></I></S>Intersection Priority<E></E> than the insulation but lower than your facade surface, it should clip one and not the other.<BR /> <BR /> <BR /> Ling. Mon, 14 May 2018 01:15:31 GMT https://community.graphisoft.com/t5/Modeling/Wall-problem/m-p/290342#M149981 Lingwisyer 2018-05-14T01:15:31Z