https://community.graphisoft.com/t5/Modeling/alignment-drag-beam/m-p/290629#M150113 If you have your 'Snap Points' turned on and set to 'Half', then when you touch an edge of the beam in section you will get a half snap point.<BR /> Now you can drag from there to where ever you want.<BR /> <BR /> You could also use the 'Align' tool (Special align - centre note with draw line arc).<BR /> But I don't think this is as good as it is not really intended to be used in this situation.<BR /> <BR /> <BR /> Barry. Fri, 23 Oct 2020 02:22:03 GMT Barry Kelly 2020-10-23T02:22:03Z https://community.graphisoft.com/t5/Modeling/alignment-drag-beam/m-p/290628#M150112 <DIV class="actalk-migrated-content"><T>Hello,<BR /> I need to move the beam from center to the center of a colum, but can not find the mid point of the beam which can drag to the center of a colum,<BR /> is there any way similar to Revit auto alignment?<BR /> Thanks</T></DIV> Fri, 26 May 2023 10:25:19 GMT https://community.graphisoft.com/t5/Modeling/alignment-drag-beam/m-p/290628#M150112 Anonymous 2023-05-26T10:25:19Z https://community.graphisoft.com/t5/Modeling/alignment-drag-beam/m-p/290629#M150113 If you have your 'Snap Points' turned on and set to 'Half', then when you touch an edge of the beam in section you will get a half snap point.<BR /> Now you can drag from there to where ever you want.<BR /> <BR /> You could also use the 'Align' tool (Special align - centre note with draw line arc).<BR /> But I don't think this is as good as it is not really intended to be used in this situation.<BR /> <BR /> <BR /> Barry. Fri, 23 Oct 2020 02:22:03 GMT https://community.graphisoft.com/t5/Modeling/alignment-drag-beam/m-p/290629#M150113 Barry Kelly 2020-10-23T02:22:03Z