https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30990#M15255 "Bring to front" only affects 2D floor plan display, not sections.<BR /> <BR /> Sections are essentially special parallel 3D views rendered with the Internal engine. If the beam is hidden by a wall and you want to see it, place the wall on a hidden layer or make the wall transparent or simply move the wall or beam so the beam can be seen. Mon, 18 Feb 2008 18:36:32 GMT Thomas Holm 2008-02-18T18:36:32Z https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30988#M15253 <DIV class="actalk-migrated-content"><T>Why is that the beam in a section goes behind the wall? When I make "Bring to front" it always stays behind. Anyone knows why?</T></DIV> Fri, 26 May 2023 10:33:58 GMT https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30988#M15253 Anonymous 2023-05-26T10:33:58Z https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30989#M15254 <BLOCKQUOTE>Ruben wrote:<BR />Why is that the beam in a section goes behind the wall? When I make "Bring to front" it always stays behind. Anyone knows why?</BLOCKQUOTE> Beams have priorities like walls do. Make it higher than the corresponding wall has. Mon, 18 Feb 2008 13:57:27 GMT https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30989#M15254 Anonymous 2008-02-18T13:57:27Z https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30990#M15255 "Bring to front" only affects 2D floor plan display, not sections.<BR /> <BR /> Sections are essentially special parallel 3D views rendered with the Internal engine. If the beam is hidden by a wall and you want to see it, place the wall on a hidden layer or make the wall transparent or simply move the wall or beam so the beam can be seen. Mon, 18 Feb 2008 18:36:32 GMT https://community.graphisoft.com/t5/Modeling/Section-problem/m-p/30990#M15255 Thomas Holm 2008-02-18T18:36:32Z