topic Re: Fillet morph in Modeling

Fillet morph

Anonymous — Wed, 24 May 2023 17:23:41 GMT

I am trying to fillet two edges of a morph that merge into a corner. I can only fillet one of the edges if I try to fillet the other a pop up dialogue says, radio too large... you can fillet the edge.
Any answers?

Re: Fillet morph

DGSketcher — Tue, 19 Jun 2018 20:36:26 GMT

See if this helps...

https://helpcenter.graphisoft.com/guides/archicad-22/archicad-22-reference-guide/elements-of-the-virtual-building/construction-elements/morphs/basic-morph-editing/basic-morph-editing-fillet-chamfer-a-morph/

Re: Fillet morph

Barry Kelly — Wed, 20 Jun 2018 01:12:33 GMT

You must select both edges at the same time, then fillet and apply to all edges.

Barry.

Re: Fillet morph

Anonymous — Mon, 25 Jun 2018 09:36:17 GMT

How can I select both edges at the same time. It seems imposible to me.

Re: Fillet morph

Barry Kelly — Mon, 25 Jun 2018 09:41:17 GMT

The same as you do for other elements, by holding the SHIFT key to add or subtract from your selection set.
But because you are talking about individual edges of a morph, you must make sure that the selection tool is in sub-element mode.
Or use CTRL+SHIFT to temporarily enter sub-element selection mode.
The CTRL key toggles this mode on while you hold it.

Barry.