topic Re: Beam Intersections Not Cleaning up in Modeling

Beam Intersections Not Cleaning up

4hotshoes — Thu, 09 Dec 2021 16:28:44 GMT

I am using the Beam Tool to make footings and the intersections will not clean up. They are all at the same elevation and the setting is on to clean them. They all are flat and level. I don't usually see this problem. All of the endpoints are connected. Any Ideas on how to make them join?

Re: Beam Intersections Not Cleaning up

Barry Kelly — Fri, 10 Dec 2021 00:35:59 GMT

I am assuming they are all in the same layer.

Is the Intersection Priority Number for that layer set to 0 (zero)?

They won't trim if it is.

Barry.

Re: Beam Intersections Not Cleaning up

Rico — Fri, 10 Dec 2021 07:14:13 GMT

Did you accidentally deactivate this option:

Re: Beam Intersections Not Cleaning up

Lingwisyer — Fri, 10 Dec 2021 08:47:03 GMT

They all are flat and level.

As in they have no depth? Unless they have changed something, things do not connect when they have a thickness of ZERO... Can you make then 0.01 instead?

Ling.

Re: Beam Intersections Not Cleaning up

4hotshoes — Wed, 15 Dec 2021 15:08:59 GMT

The layer they are on have the intersection priority set to "1" not "0"

Re: Beam Intersections Not Cleaning up

4hotshoes — Wed, 15 Dec 2021 15:10:09 GMT

Ye that was the first thing I checked and said so in my first post. "intersection clean up" is on

Re: Beam Intersections Not Cleaning up

4hotshoes — Wed, 15 Dec 2021 15:12:25 GMT

No. They are all set to 12" thickness, not zero.