https://community.graphisoft.com/t5/Modeling/I-cannot-make-the-New-Mesh-Points-box-appear/m-p/333649#M158114 <P><a href="https://community.graphisoft.com/t5/user/viewprofilepage/user-id/31009">@lynden</a>&nbsp;, maybe the splines are extending out of the mesh boundaries, or they are so close to each other so try to zoom in enough to select only one spline.</P> Sun, 27 Mar 2022 02:01:21 GMT Mahmoud Qenawi 2022-03-27T02:01:21Z https://community.graphisoft.com/t5/Modeling/I-cannot-make-the-New-Mesh-Points-box-appear/m-p/333643#M158111 <P>I have done contouring of my mesh before. I have clear instructions. For some reason this time (after selcting the mesh and then the mesh tool) when I hold the space bar down and hover then click on the spline, the splines join into a loop. I also don't have the the New Mesh Pints box appear. Any ideas?</P> Sun, 27 Mar 2022 00:39:23 GMT https://community.graphisoft.com/t5/Modeling/I-cannot-make-the-New-Mesh-Points-box-appear/m-p/333643#M158111 lynden 2022-03-27T00:39:23Z https://community.graphisoft.com/t5/Modeling/I-cannot-make-the-New-Mesh-Points-box-appear/m-p/333649#M158114 <P><a href="https://community.graphisoft.com/t5/user/viewprofilepage/user-id/31009">@lynden</a>&nbsp;, maybe the splines are extending out of the mesh boundaries, or they are so close to each other so try to zoom in enough to select only one spline.</P> Sun, 27 Mar 2022 02:01:21 GMT https://community.graphisoft.com/t5/Modeling/I-cannot-make-the-New-Mesh-Points-box-appear/m-p/333649#M158114 Mahmoud Qenawi 2022-03-27T02:01:21Z