https://community.graphisoft.com/t5/Modeling/Walls-with-projections-complex-profile-amp-composite-mix/m-p/32760#M16231 <DIV class="actalk-migrated-content"><T>New Archicad user here........ <BR /> <BR /> I'm trying to build a wall that has projections (brick corbels) &amp; a profiled wall cap. I've gone the route of doing it using the complex profile. Starting off fresh, I can get the profile to work in section. When I try to put a window (any from the standard library), the program stalls with script errors. <BR /> <BR /> Then I tried it another way, that is, starting with a composite wall as a base &amp; then applying the corbelling &amp; cap to the wall. Its no problem to get the composite wall to make a rectangular building. <BR /> The corbelling I made using, yet again, the complex profile. Thinking that when the profile wraps a corner, it will miter itself. It doesnt though. The profile stops about a foot or so from each of the corners. <BR /> <BR /> I'm at a loss on how to do this. I just want the corbelling to show up on the section &amp; on the elevation. It would be nice if the actual brick or block coursing would show in the section as well. <BR /> <BR /> Can anyone help? <BR /> thanks</T></DIV> Fri, 26 May 2023 13:06:55 GMT Anonymous 2023-05-26T13:06:55Z https://community.graphisoft.com/t5/Modeling/Walls-with-projections-complex-profile-amp-composite-mix/m-p/32760#M16231 <DIV class="actalk-migrated-content"><T>New Archicad user here........ <BR /> <BR /> I'm trying to build a wall that has projections (brick corbels) &amp; a profiled wall cap. I've gone the route of doing it using the complex profile. Starting off fresh, I can get the profile to work in section. When I try to put a window (any from the standard library), the program stalls with script errors. <BR /> <BR /> Then I tried it another way, that is, starting with a composite wall as a base &amp; then applying the corbelling &amp; cap to the wall. Its no problem to get the composite wall to make a rectangular building. <BR /> The corbelling I made using, yet again, the complex profile. Thinking that when the profile wraps a corner, it will miter itself. It doesnt though. The profile stops about a foot or so from each of the corners. <BR /> <BR /> I'm at a loss on how to do this. I just want the corbelling to show up on the section &amp; on the elevation. It would be nice if the actual brick or block coursing would show in the section as well. <BR /> <BR /> Can anyone help? <BR /> thanks</T></DIV> Fri, 26 May 2023 13:06:55 GMT https://community.graphisoft.com/t5/Modeling/Walls-with-projections-complex-profile-amp-composite-mix/m-p/32760#M16231 Anonymous 2023-05-26T13:06:55Z