https://community.graphisoft.com/t5/Modeling/walls-not-intersecting/m-p/272440#M166609 Ideally all of the wall reference lines should intersect at one point.<BR /> Then try adjusting the junction order value to manipulate which wall trims to which.<BR /> Unfortunately only two walls will trim properly and the third will just butt in.<BR /> <BR /> If you still can”t get it to work or the 3 ref lines do not join at one point, then have the 2 left walls trimming as you have now.<BR /> Then adjust the length of the ref line of the third wall so it overlaps the other walls but does not touch the ref line of the other walls - otherwise they will just trim as they are now.<BR /> <BR /> It may mean you have to change the position of the ref lines on the 2 left walls (to the very left side) so they are out of the way.<BR /> <BR /> Barry. Sat, 22 Dec 2018 07:44:38 GMT Barry Kelly 2018-12-22T07:44:38Z https://community.graphisoft.com/t5/Modeling/walls-not-intersecting/m-p/272439#M166608 <DIV class="actalk-migrated-content"><R>Please see attached for an image. What do I do to so the walls can intersect?</R></DIV> Fri, 19 May 2023 20:34:17 GMT https://community.graphisoft.com/t5/Modeling/walls-not-intersecting/m-p/272439#M166608 dhnguyen 2023-05-19T20:34:17Z https://community.graphisoft.com/t5/Modeling/walls-not-intersecting/m-p/272440#M166609 Ideally all of the wall reference lines should intersect at one point.<BR /> Then try adjusting the junction order value to manipulate which wall trims to which.<BR /> Unfortunately only two walls will trim properly and the third will just butt in.<BR /> <BR /> If you still can”t get it to work or the 3 ref lines do not join at one point, then have the 2 left walls trimming as you have now.<BR /> Then adjust the length of the ref line of the third wall so it overlaps the other walls but does not touch the ref line of the other walls - otherwise they will just trim as they are now.<BR /> <BR /> It may mean you have to change the position of the ref lines on the 2 left walls (to the very left side) so they are out of the way.<BR /> <BR /> Barry. Sat, 22 Dec 2018 07:44:38 GMT https://community.graphisoft.com/t5/Modeling/walls-not-intersecting/m-p/272440#M166609 Barry Kelly 2018-12-22T07:44:38Z