topic Re: Rounded type stone wall base - Custom Profile? in Modeling

Rounded type stone wall base - Custom Profile?

rob2218 — Fri, 19 May 2023 20:42:18 GMT

see attached.

Re: Rounded type stone wall base - Custom Profile?

Barry Kelly — Tue, 12 Nov 2019 01:17:05 GMT

I think you only have 2 options.
One is to model each stone individually - not impossible but not very practical.
Or create a complex profile as you have done, so it look reasonable in section.
Apply a surface material that has a stone hatch associated so it looks good in elevation.
That surface material could also be set up with bump map and displacement so it looks a bit lumpy in renderings as well if that is important.

Barry.

Re: Rounded type stone wall base - Custom Profile?

rob2218 — Tue, 12 Nov 2019 02:30:30 GMT

thanks Barry.
I thought that was the case.
it seems there is no way to create an irregular type stone profile like that.
I suppose that if I tried to just do that jagged shaped profile....it may end up looking strange cause you'll see horizontal lines running across the base too evenly huh?

hum...I may just do a slanted wall, add some texture map to it with some vectoral hatch pattern of similar round stones and call it a day.
Seems that's my only recourse.

Re: Rounded type stone wall base - Custom Profile?

Barry Kelly — Tue, 12 Nov 2019 02:49:51 GMT

rob2218 wrote:
I suppose that if I tried to just do that jagged shaped profile....it may end up looking strange cause you'll see horizontal lines running across the base too evenly huh?

Not if you use a spline to create the profile.
Curves won't show any horizontal lines (unless you see the top or bottom of the curve).

Barry.

Re: Rounded type stone wall base - Custom Profile?

Erwin Edel — Tue, 12 Nov 2019 12:24:33 GMT

How about a wobbly line for the outline of the shape for section and just keep it as the 'box' shape for vectorial hatch and texture?

Re: Rounded type stone wall base - Custom Profile?

rob2218 — Tue, 12 Nov 2019 16:55:08 GMT

I could use a spline but any curved line when put into a profile causes havoc at corners if they aren't exactly meeting up just right. Strange Archicad resolution issues occur.
Besides, a curved line will take longer to process too and it's not that important to have.
Also, I could use that "sketchy" linetype as the profile linetype and just use a flat, canted sloping wedge of a profile. Maybe that's the way to go.

Trick the section into looking like a wiggly line, yet have the 3d model just have a flat canted wedge profile as the stone base and have texture on it.....

Re: Rounded type stone wall base - Custom Profile?

Erwin Edel — Wed, 13 Nov 2019 07:53:11 GMT

rob2218 wrote:
Also, I could use that "sketchy" linetype as the profile linetype and just use a flat, canted sloping wedge of a profile. Maybe that's the way to go.

Trick the section into looking like a wiggly line, yet have the 3d model just have a flat canted wedge profile as the stone base and have texture on it.....

That's excactly what I meant