topic Re: cut floor plan vs morphs in Modeling

cut floor plan vs morphs

Claudio Lima — Wed, 14 Jun 2023 16:13:38 GMT

hi all !

I'm importing an STRUCTURE IFC as morphs, and the problem is :

the slab, the is below 0.00 floor , so it does not appear on the floor plan.

all the tests I made, I can make what I want but, not for IFC hotlink... ie, if the morph is set to ONW STORY ONLY, it works.

but, hotlinking the IFC, it doesn't allow me that option

any help ? idea ?

tnks

regards

claudio

mija — Thu, 15 Jun 2023 05:35:53 GMT

My practice is that I first import ifc in individual archicad where I adjust all the stories, then I hotlink it to the file.

Claudio Lima — Thu, 15 Jun 2023 10:33:54 GMT

hi mija !

tnks, but that's not the problem...., see the attach image, to see what im talking about

mija — Thu, 15 Jun 2023 10:50:22 GMT

Did you try relinking them to the story you want to see them?

Claudio Lima — Wed, 21 Jun 2023 16:13:20 GMT

hello myja !

watch the video attached...

regards

Mahmoud Qenawi — Thu, 22 Jun 2023 00:39:03 GMT

You tried to change the cutting level from floor plan cut plan dialogue by setting show down to the lower floor to GF by 0.10m, It works for me.

Claudio Lima — Thu, 22 Jun 2023 11:07:29 GMT

hi mahmoud !

please send me an image of that setting

Mahmoud Qenawi — Thu, 22 Jun 2023 15:27:45 GMT

Check this from Archicad help,

Claudio Lima — Thu, 22 Jun 2023 16:25:43 GMT

this I already know...., I was wondering why your file, was ok